Reply To: Graph labels
Home › Forums › Tactile Graphics › Graph labels › Reply To: Graph labels
May 17, 2010 at 4:53 pm
#20332
Chris Clemens
Keymaster
Your .meg file should be converted to a .bfm file which could be picked up in other programs. Your next attachment was a .doc file (Word) rather than .abt file (Brl2000), so I couldn't open that properly either. At any rate, I've quickly done up a sample and saved it as a .jpeg which I will attach. As indicated earlier, I think the best approach would be to move the vertical values closer to the left. Since the right side of the graph shows a partial "cell", it wouldn't hinder the reading of the graph is the left side also portrayed a partial "cell".
Good luck!
edited by betty.marshall on 5/17/2010
edited by betty.marshall on 5/17/2010